ID 02-4








 

 

 

 

 

 

 

 

 
 





Component Services Brisbane  

 

 

Hawker Pacific Component Services Brisbane was established in 2004 from its piston engine overhaul business which was transferred internally to another site. The aim of this business decision was to set up a centre of excellence providing component support to the regional and airline markets. In August 2009 Component Services moved its operations off Archerfield airport into a more favorable work environment at 18 Selhurst Street Coopers Plains Brisbane. The smaller leaner operation now sports some modern amenities and includes well set out work areas incorporated into the facility using value stream mapping concepts to ensure quick turn times.

Benifits:
Major Cost benefits in comparison to OEM servicing options
Quality assured through systems, certification and OEM linkages
Linkages to OEMs – approved data, access to OEM technical service
Short workshop turn around times, set for urgency level
Easy and real access to point of contact
Significant ‘reach back’ into Hawker Pacific
Ability to quickly expand Airworthiness Approvals
Workshop back up
Technical advice
Competitive pricing
In house warranty support on selected products
Rotable units available
Technical assistance

Landing Gear Components
  Component Services Brisbane if fully equipped to repair/overhaul a variety of wheel, brakes and landing gears from OEM’s including Goodrich, Meggitt Aircraft Braking Systems and Honeywell. In house spares provisioning, machining capability and NDT facilities equals quick turn around times.
Machining Capabilities
  The Component Services Brisbane Machine Shop Specializes in machining of structural and undercarriage associated components. Manufacture, installation and finishing of bushes/sleev
Starter Generators
  The Component Services Brisbane Starter Generator workshop is approved by under a Goodrich Power Systems ARC (Approved Repair Centre)
Sheet Metal and Composite Workshop
  Sheet metal and composite items are processed through a well equipment workshop purposely set up for small to medium size components. Composite components are processed utilizing a negative pressure dirty room with Nederman filtration and an environment controlled lay up clean room, dehumidified and temperature controlled
Technologies
  Cleaning and Surface Finishing
Carbon and Paint Removal
(1.7 x .8 meter capacity)
Degreasing
Oil Cooler Pressure Cleansing
Plastic Media Blasting
(1.2 x 1.2 x 1 metre capacity)
Wet Grit Blasting
Alodining
Polyurethane Painting

Non Destructive Inspection (NDI)
Eddy Current:
Phase Analysis
Magnetic Particle:
Bench 5,000 Amp AC/DC
Portable Yokes
Dye Penetrant:
Fluorescent Penetrant (Water Washable and Solvent Removable)

Stress Relieving and Heat Treatment
High Temperature Oven
Hardness Testing
General Capabilities
 

Component Overhaul
Airframe
Mechanical and Hydraulic Actuators
Wheels and Brakes
Undercarriage
Retract Gearbox & Mechanisms
Heat Exchangers
Engine Isolation Mounts
Starter Generators
Heat exchangers
Pre Coolers
Oil coolers
Condensers

Structural - Composite and sheet Metal
Leading edges
Air stairs
Doors
Exhaust fingernails
Jet pipes
Fuel tank panels
Cowlings
Fairings
Manufacturing
 

Machined Parts
Sheet metal parts
Aeroquip Hose Supply
Rubber
Low pressure
Medium Pressure
Wire Reinforced
Teflon
Medium Pressure
High Pressure
Compression Crimp